DQ-500 Series Drill Unit
Overview
Stroke Lengths – 6″, 8″, 10″ and 12″
Drill capacity – Determined by feed pressure and motor horsepower.
Tap Capacity – Determined by feed pressure and motor horsepower.
Drill Point Thrust:
- Piston Area -16.49 sq. in.
- 1649 lbs. drill point thrust @ 100 psi air pressure
- 4122 lbs. drill point thrust @ 250 psi hydraulic pressure
Torque Rating – 900 in. lbs.
Spindle Speed – 3,600 RPM max. (maximum with pre-greased bearings; higher RPM with special bearings or air mist lubrication on bearings.)
Spindle – #3 or #4 Morse Female Taper Standard. Full options available.
Spindle Drive – From offset motor thru pulleys and belts to unit pulley shaft.
| Model | Stroke | A | B | C | ||
|---|---|---|---|---|---|---|
| DQ-56 | 6″ | 9.84 | 14.78 | 33.84 | .63 | 11.56 |
| DQ-58 | 8″ | 11.84 | 16.78 | 39.84 | 2.63 | 13.59 |
| DQ-510 | 10″ | 13.84 | 18.78 | 45.84 | 4.63 | 15.59 |
| DQ-512 | 12″ | 15.84 | 20.78 | 51.84 | 6.63 | 17.59 |
Additional information
| Drill Capacity Steel (inches) | 1" + |
|---|---|
| Tap Capacity Steel (inches) | 1" + |
| Stroke Length (inches) | 6 to 12" |
| Thrust @ 100 psi hyd. (pounds) | 1649 |
| Thrust @ 200 psi hyd. (pounds) | 4122 |
| Torque (in-lbs) | 900 |
