Idea Center
Right-Angle Milling Head
Shown here is a Hypneumat M350EHB unit with a right-angle milling head. The unit is powered by a 1.5 HP 1762 rpm brake motor and includes a push type hydra-brake and spindle positive stop.
10” Stroke Drilling Units
Here are four Hypneumat DQ310EHB drilling units with ER40 spindles and 2 HP 3600 rpm motors. The motors are mounted using our motor mount belt guard. Per customer’s request, the units have 10″ of stroke, silicone-filled hydra-brakes, sealed bearings, and oversized...
5 Drilling Units with Commander 850 Multi-Heads
These five M style units are equipped with Commander 850 series multi-heads. The multiple spindles heads each include guide rods and five adjustable spindles.
FX34 with Counterbalance
The Hypneumat FX34 Ball Screw Rail Unit has 4″ of stroke, is equipped with a 1-3/8″ straight bore spindle, a counterbalance, and has servo motors for the linear feed and spindle speed. This auto-feed unit will perform a tapping operation. The servo motors allow for...
Billet Style 4-Spindle Head
Hypneumat made this custom billet-style 4-spindle multi-head for a customer’s application. This head is powered by a Hypneumat DQ46EHB auto-feed drilling unit.
Dual Tapping LS46E Units
This Hypneumat Machine uses two opposing heavy duty LS46E leadscrew tapping units with floating tap holders and is wired with full controls, ready for the customer to mount their part holding fixture.
DQ500 and Commander 4-36
This Hypneumat DQ56EHB drilling machine drives an 8-spindle Commander 4-36 multi-head. The machine rests on a 54″ by 48″ table and uses a 5 HP 1200 rpm motor.
M200EHB with Air Motor
Shown here is one of our M200EHB series drilling units with a 1 HP 2000 rpm Gauss air motor. Air motors were utilized for this application because of their smaller motor frame allowing for multiple units to be mounted in line to drill close-center holes. This unit has...
Commander 8-12 with Adjustable Spindles
This Commander 8-12 series multiple-spindle head has 12 universal joint spindles. These collet style spindles can be adjusted for different hole patterns.
Three M Units with Tight Pattern
These three M-series (direct drive) units with varying lengths are capable of drilling holes at closer centers that would not otherwise be possible with our standard auto feed drilling units. The center unit has an extended rear housing so the 1 HP, 3600 rpm motors...
Connect With Us